DRY 65 DEHUMIDIFIER

Ventilating - Fixed Installation

At 13” tall and 12” wide,this compact, cost-effective, high-performing
dehumidifier is small enough to fit in a utility closet, or to be hung out of
sight in a drop ceiling

65 pints of water removal per day (80° F/60%RH)
Requires only 5.5 amps/115V

DRY 90 DEHUMIDIFIER

Ventilation - Fixed Installation

The Quest DRY 90 provides additional filtration up to MERV-14 efficiency
and captures 95% of all airborne particles creating an ultra-safe and healthy
work environment.

90 pints of water removal per day (80°F/60%RH)
Requires only 6.3 amps/115

HI-E DRY 100 DEHUMIDIFIER

Plug-And-Play Installation

Hi-E Dry dehumidifiers are designed for free-standing or ducted installations.
The Hi-E DRY 100 is perfect for the heavier moisture loads common in
Athletic facilites.

106 pints of water removal per day (80°F/60%RH)
Requires only 7 amps-115V

HI-E DRY 195 DEHUMIDIFIER

Plug-And-Play Installation

Hi-E Dry dehumidifiers are designed for free-standing or ducted installations.
The Hi-E DRY 195 is also perfect for the heavier moisture loads common in
Athletic facilites. Pools, spas, locker rooms and exercise areas demand
higher capacity equipment to eliminate mold, mildew and their odors.

183 pints of water removal per day (80°F/60%RH)
Requires only 12 amps-115V

HI-E DRY VEHERE DEHUMIDIFIER

Plug-And-Play Installation

The intended application of the Hi-E DRY Vehere is as a pool & spa area
humidity sensing controller applied either as a free-standing device directly
in the pool area or operated remotely to provide dehumidified air to the
pool or spa area using optional ducting and remotely mounting the humidity
controler. 185 pints of water removal per day (80°F/60%RH)
Requires only 12 amps-115V

AIR AMS C10

Air Moving Systems

The Quest Air AMS C10 and AMS C10+ centrifugal air movers
produce airflow velocities of over 1000 CFM (2700 FPM), while
using only 2.8 amps of electricity on high speed. The unique
1/3 horsepower design of the Quest Air AMS C10 and C10+,
coupled with a two-speed switch, delivers maximum airflow
using minimum amps. Both are lightweight, stackable, and
have superior cord management.

The Quest Air AMS C10+ also features an on-board duplex GFCI
outlet and convenient circuit breaker. Air velocities of 1000 CFM
2.8 amps (high)/2.4 amps (low)

CLEAN AFS 14

Air Filtration System

The Quest Dry AFS 14  HEPA System is a portable air scrubbing
device designed to capture virtually all removable airborne particles.
At the recommended minimum of four air changes per hour, a single
Quest Clean AFS 14 can control up to 21,000 cubic feet.  With its optional
4-stage absorption filter, Quest Clean AFS 14 also removes airborne odors and chemicals.

The Quest Clean AFS 14 HEPA System is extremely versatile with its
multiple ducting and filtration options. This provides the unique ability
to continually filter the indoor air and depressurize the jobsite to prevent
the spread of contamination.

DRY 77 DEHUMIDIFIER

Plug-And-Play Installation

The attractive design and quiet operation makes the Quest Dry 77 ideal for
classrooms, libraries, offices and lounges. an optional HEPA and activated
carbon filter attachment is available. HEPA filtration captures 99.97% @ .03
microns of airborne particles. The carbon filter option removes airborne odor
and chemicals from the work environment as well.

77 pints of water removal per day (80°F/60%RH)
Requires only 6.3 amps-115V

DRY 115 DESICCANT DEHUMIDIFIER

Plug-And-Play Desiccant

The Quest DRY 115 is designed to operate vertically or horizontally, and
accommodates multiple ducting scenarios. Two standard 115VAC power
cords are included and, after correctly directing the wet reactivation air, the
Quest DRY 115 can simply be plugged in and turned on.

115 pints of water removal per day (80°F/60%RH
Requires only 22 amps/115V

DRY RDS 10

Refrigerant Drying System

The Quest Dry RDS 10 combines the high performance of larger
dehumidifers into a compact, state of the art, roto-mold design. A solid
state control panel featurers a lighted hour meter, pump purge control
and a defrost light. The recessed 12-inch wheels, compact design and
balanced weight distribution make the Quest Dry RDS 10 easy to handle,
even in the tightest of spaces..

80 pints (10 gallons) of water removal per day (80ºF/60%RH)
Requires only 5.4 amps/115V

AIR AMS A30

Air Moving Systems

The Quest Air AMS A30 and 30+ not only produce air velocities greater
than competitive products, but through patented design focus those velocities
on hard-to-dry areas such as carpet and pad, sub-floor and walls.

The Quest Air AMS A30+ features an operator interface that is conveniently
located for easy access and features a power indicator lamp, a 3-position switch,
an hour meter, a GFCI outlet, and a circuit breaker – eliminating trips to the breaker box.

Air velocities of 3000 CFM
2.5 amps (high)/1.9 amps (low) it

DRY DDS 15

Desiccant Drying System

The Quest Dry DDS 15 provides more water removal (in certain conditions)
and a wider operating range than refrigerant based dehumidifiers.  The
Quest Dry DDS 15 is designed to operate vertically or horizontally, and
accommodates multiple ducting scenarios. Two standard 115VAC power
cords are included and, after correctly directing the wet reactivation air, the
Quest Dry DDS 15 can simply be plugged in and turned on.  An available
low voltage control kit allows the Quest Dry DDS 15 to be controlled by a r
emote dehumidistat, timer, or switch.

115 pints (15 gallons) of water removal per day (80ºF/60%RH)
Requires only 22 amps/115V

DRY DDS 43

Desiccant Drying System

The Quest Dry DDS 43 has been designed from the ground up for simple,
quiet, reliable operation under the harshest of conditions. It offers both
a constant-run mode for maximum operation and a humidistat controlled
|mode for sensitive climates. The Quest Dry DDS 43 is energy efficient
and high performing. The DDS 43 is a 230 volt - single phase unit with
selectable 25 or 40 amp draw, removing 43 gallons of water per day at AHAM.

Portable, reliable, easy to use, the Quest Dry DDS 43 is the perfect commercial
and industrial drying solution.

344 pints (43 gallons) of water removal per day (80ºF/60%RH)
Selectable 25 or 40 amp draw,
230V single phase unit

COOL ACS 12

Air Cooling System

The Quest Dry ACS 12 portable air conditioner boasts one ton
(12,000 BTUs) of cooling capacity operating in 95°F and 60%
conditions while drawing under 12 amps. In a single pass, this
provides a 15 degree temperature drop on the 430 CFM air stream
and water removal equivalent to 100 pints per day.

The Quest Cool ACS 12 gives the technician or contractor vital
temperature control in the working area to optimize drying efficiency
and safeguard occupant comfort on the jobsite. The Quest Cool
ACS 12’s cooling power also makes it the ideal accessory to pre-treat
air to improve the performance of dehumidifiers when humidity control
is an issue. The Quest Cool ACS 12 features thermostatically controlled
cooling to insure maintenance of desired conditions and prevent potential
over-cooling. Set-up and operation is simple using only a 15 amp outlet. 

100 pints (12.5 gallons) of water removal per day (95ºF/60%RH)
Requires only 11.7 amps/115V 

Dry DDS 125

Desiccant Drying Systems

The Quest DRY DDS 125 The Quest Dry DDS 125 Desiccant
offers 1800 CFM of process airflow in a convenient trailer-mounted
package. The DDS 125 removes 125 gallons of water per day
(1000 pints) at AHAM conditions while drawing only 16 amps of
electricity at 115 volts. The DDS 125 can run for up to 6 days on
only 100 gallons of propane, beating all other desiccants in its class.

The Quest Dry DDS 125 is constructed of durable, weather resistant
stainless steel and uses an advanced silica gel rotor. The DDS 125
includes an enclosed 16’ tandem axle V-nose trailer with electric brakes
and 120 gallon DOT approved propane cylinder, providing the user a
complete mobile drying system with plenty of space to store additional equipment

1000 pints (125gallons) of water removal per day (80ºF/60%RH)
Requires only 16 amps/115V